Needak Stabilizing Bar Assembly Instructions

	The needak stabilizing bar attaches to two legs as illustrated in the photo.
	To attach the bar you will first need to remove the rubber feet from the two legs that you have selected to support the bar. If the feet do not come off easily, a flat head screwdriver may be used to help push them off. You can also use a blow dryer to heat the foot up which will help it to slide off more easily. When repositioning the foot after the bar has been attached a small amount of Vaseline can be applied to the inside of the foot to help it slide on more easily.
	After removing the rubber foot slide the vertical segment of the stabilizing bar over the rebounder leg and then replace the rubber foot.
	Position the bar legs so that the spring buttons are perpendicular with the rebounder frame.
	Connect the two sections of the stabilizing bar by depressing the spring buttons while pressing the two sections together.
	You next need to determine the "front" of the stabilizing bar. When standing on the floor in front of the rebounder, the spring button will be on the left.
	Next position the top portion of the stabilizing bar over the bar legs. Slide it down evenly to the desired height then lock it in place with the spring buttons.
	Note the stabilizing bar will flex slightly while you are bouncing. This is by design and an necessary feature to prevent injury.